OSSC v1.5 ja v1.6 LÄPINÄKYVÄ NEONVIHREÄ VAIHTOKUORI

Jos olet kyllästynyt tavallisiin tylsiin mustiin kuoriin, niin nämä kuoret loistavat valossa neonkeltaisenvihreänä ja ovat läpinäkyvät.
Internetistä löytyy ohjeita kuorien vaihtoon mutta itse pärjäsin myös ilman ohjeita. Laserleikatut kuoret.

Nämä myynnissä olevat on käytetyt eli ei ole uudet.

Sopii OSSC version 1.5 ja OSSC version 1.6 ainakin.

Huom ainoastaan kuoret ei itse OSSC laitetta

Ohjeet asennukseen:

Start with the bottom panel first. Unscrew the four screws on the under side of the OSSC. Be careful not to lose the small nuts that act as spacers between the bottom screws and the PCB of the OSSC.

Use the hole punch to punch out the screw holes in the replacement case BEFORE removing the protective cover. Please dispose of these small pieces of plastic carefully, remembering that small micro-plastics like this can be a hazard to the environment.

Now, remove the protective film from the replacement case, check the alignment carefully, if the case piece is upside down, the SD card access slot will not line up.

Note that the CE sticker on the bottom of the OSSC is designed to be permanent and cannot be removed. Please retain the bottom panel as it displays your CE sticker and you may require this if you need to have your OSSC serviced.

Ensure the bottom piece is secure before moving on to the top two pieces. Be careful not to lose the plastic spacers between the case pieces on the OSSC.

To remove the middle case piece you will need to remove the nut and washer that is around the power switch. Normally this is loose enough so it can be undone by hand. If not, please use a suitable spanner.

To finish up, carefully peel the plastic feet from your old case and apply them to the bottom of the new one. If you find that your plastic feet no longer stick, we will have replacements available in the store soon.